LED RV Chandelier

by Greg Zimmerman

At the Florida Egg and Smore’s rally, our neighbor asked me to install a neat light they had bought. It’s a Heng’s LED RV chandelier. Made in the USA, it has 4 strips of LEDs and really brightens up the Casita’s interior. It’s available in clear or frosted lenses and “cool” or “warm” LEDs. We went with “warm” for our Casita as I find the “cool” a little harsh on my eyes.

I had to drill a hole in a specific spot to allow for clearance for the push button on-off switch. Next I hooked up the light switch to the fan’s power wires. Be sure to tap the wires before the 3 speed fan resistor, or the light won’t work right. For tapping the wires, I use yellow posi-taps (12 gauge) and a blue heat-shrink splice connector.

The pushbutton switch next to the “in-out” switch on the fan
The back side of the switch. There’s not a lot of room for error.
White tapped into white, black from switch connects to black on light and into black fan wire with a tap.

Finally, 1/2″ stainless steel screws are driven into the frame of the fan to hold it into place.

3 comments

Lee February 23, 2019 - 11:26 am

Real nice installation and I like the warm white as well. Ive got a feeling that these are going to be a popular item once people see your mod.

Reply
Gigi February 23, 2019 - 3:36 pm

I think a disco ball would be better

Reply
Chris B September 8, 2019 - 8:04 pm

Thanks for posting. I’ve been wanting a one switch light to light the entire cabinet and this is it. Thanks for the installation tips and introducing me to Posi Products. They are wonderful and so much easier than anything else on the market.

Reply

Leave a Comment